Fuses are located on the right hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.
Fuel Shut Off Valve
The fuel shut off valve is located at the right rear
of the seat. The valve has three positions: right
tank, left tank and OFF.
IMPORTANT INFORMATION
Always raise the
deck to the highest position for transport.
Cutting Height
The cutting height pedals release the deck lift and
set the desired deck height. Apply pressure to the
lift pedal and rotate foot to also apply pressure to
the release pedal, unlocking the deck lift.
For transport, push the lift pedal forward until the
deck lift latches in the transport (highest) position.
Fuses
To set the deck cutting height, release deck height
control by pushing forward on the pedal. Rotate
the cutting height pin 180
O
to remove it and slip
the pin into the hole for the desired cutting height.
The cutting height can be set from 1"- 5".
15
CONTROLS
Summary of Contents for PZ 60
