husqvarna auTOMOWEr
™
sOlar hybrid
quiCK GuidE
5
Main menu
Commands
Timer
Garden
Settings
Garden - Follow loop - Test IN
4b
1
4a
Adjust the mower to suit the size of your lAwn
The mowing results depend on mowing time. Adjust the
mowing time to suit your garden using the Timer function.
If the mower works too often: The lawn will appear trampled
down.
If the mower works too seldom: The lawn will not be properly
cut.
timer
Adjust the mower for nArrow pAssAges
Narrow passages in the garden make it difficult for the
mower to find the charging station. Test to see if the mower
finds its way home using the
Test IN function.
1. Look for the narrowest passage in the garden (between the
boundary loops).
2. Place the mower beyond the passage, with its front facing
the boundary loop.
3. Activate the Test IN function (Garden - Follow loop - Test IN) and
start the mower.
4. Ensure that the mower follows the boundary loop through
the passage.
a. If the mover travels through: The test is complete.
a. If the mover does not travel through: Lower the value of
the Corridor width, boundary by 1 unit. Restart the test
from point 2.
guide wire
See chapter 3.8 Installation of the guide wire in the
Operator’s Manual.
If you have a complicated garden or it has narrow passages
(less than 2 m / 7 ft), we recommend installing a guide wire.
The guide wire is an extra wire that is run from the charging
station, out towards a remote part of the work area or through
a narrow passage. The mower can follow the guide wire to and
from the charging station.
adjusT ThE MOWEr TO suiT yOur GardEn
See chapters 6.4 and 6.5 in the Operator’s Manual.
Here you will find a few tips about important settings for your Automower.
All settings for Automower are made using the menu functions.
You decide what times of the day and days of the week the mower is to work.
Automower cuts around 90 m² / 950 ft² per hour and day. If your garden consists
of 1000 m² / 0.25 acre grass, the mower should work on average 12 hours per
day.
4b
2
1
4a
Corridor width, boundAry
Settings
Corridor width, boundary (Garden– Follow loop – Corridor width – Corridor
width, bound.)
defines the distance between the mower’s path to the boundary
wire or the guide wire when following these to/from the charging station.
The higher the stated Corridor width, the further from the loop the mover can
travel. This produces less wheel tracks than if the mover were to travel close to
the loop.
www.automower.com
AUTOMOWER is a trademark owned by Husqvarna AB. Copyright © 2008 HUSQVARNA. All rights reserved.
115 09 82-26
