G.16
TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
ENGINE OVERHAUL
Workshop Manual Ed. 12-2011
Friction plate to clutch housing clearance
Measure clearance "A" between clutch housing (2) and plate (1) with a feeler
gauge and compare measured clearance with the table below.
If measured clearance exceeds the service limit, replace clutch
plates or housing and repeat measurement. If measurement is still
outside the service limit, replace the complete clutch assembly.
Clutch spring
Measure the free length “L” of each spring with a calliper.
New spring L= 37.3 mm (1.4685 in.).
Service limit: 35 mm (1.3779 in.).
Change any spring that is outside the service limit.
STANDARD
SERVICE LIMIT
0.30-0.50 mm
(0.012-0.020 in.)
0.6 mm
(0.024 in.)
