S.5
TE 250 - 310 2012 I.E. / TE 250 - 310 2012 I.E. USA
TC 250 2012 - TC 250 2012 I.E. USA
TXC 250 - 310 2012 I.E. USA
4
5
1
H02374
2
3
6
H10164
F
TE
H10165
G
FUEL INJECTION SYSTEM
Workshop Manual Ed. 12-2011
Operation Manual for "HUSQVARNA SERVICE TOOL" for injection fuel
feeding system (TE-TXC)
The injection fuel feeding system does not require scheduled maintenance
.
The "HUSQVARNA SERVICE TOOL" part no. 8000 H3898 lets you test system
components in the event of a malfunction.
TE = A malfunction is indicated by the word "FAIL" appearing in the right-hand
portion of the dashboard display when the ignition key is set to ON and the right
switch is set to RUN.
The "HUSQVARNA SERVICE TOOL" is composed of:
1) "Diagnostic Tool" Software CD-ROM, including User Guide (PDF), Operation
Manual (PDF);
- User Guide hard-copy;
- Operation Manual hard-copy;
2) Diagnosis module part no. 8000H3902
3) Bike-module connection cable part no. 8000 H3899 (KEIHIN, MIKUNI
MY11)
4) Module-PC USB cable part no. 8000 H3903
5) Do not use
6) Do not use
After installing the Diagnostic Tool Software according to the instructions provided
in the User Guide, proceed as follows:
- Remove the front headlight fairing/number holder as described in the relevant
section;
- slip off the cap (B) of the ECU interface connector (C);
- connect the Kit cable (3) to the connector (C);
- Connect the USB cable (4) to the PC;
TE = Turn the ignition key (F) to ON
TXC = Check that switch (G) is in 'RUN position';
- start the "Diagnostic Tool" software you have installed and perform the
required tests.
In case of throttle body (H) removal and/or replacement, it is nec
-
essary to carry out the T.P.S. adjustment again by selecting the
relevant option (“T.P.S. idle adjustment”).
This diagnostic software can check the following injection param-
eters:
1 - AIR TEMPERATURE (air temperature in the intake manifold);
2 - WATER TEMPERATURE (engine coolant temperature);
3 - AIR PRESSURE (atmospheric pressure in current location and at current
altitude);
4 - THROTTLE POSITION (throttle opening rate);
5 - BATTERY (battery voltage);
6 - GEAR SHIFT POSITION (currently selected gear shift position);
7 - INJECTOR (fuel injection pulse width);
8 - IGNITION COIL (device that stores energy in the reel and discharges it to
the spark plug);
9 - O2 SENSOR HEATER (heats O2 sensor up to a temperature that will
provide a stable output);
10 - O2 SENSOR (detects lean or rich mixture).
