17
AIR FILTER
Your engine will not run properly using a dirty air
fi
lter. Ser-
vice air cleaner more often under dusty conditions.
ENGINE COOLING SYSTEM
To ensure proper cooling, make sure the grass screen,
cooling
fi
ns, and other external surfaces of the engine are
kept clean at all times.
Every 100 hours of operation (more often under extremely
dusty, dirty conditions), remove the blower housing and other
cooling shrouds. Clean the cooling
fi
ns and external surfaces
as necessary. Ensure the cooling shrouds are reinstalled.
NOTE:
Operating the engine with a blocked grass screen,
dirty or plugged cooling
fi
ns, and/or cooling shrouds re moved
will cause engine damage due to overheating.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of operation, whichever
occurs
fi
rst. Spark plug type and gap setting are shown in
“PROD UCT SPECIFICATIONS” section of this manual.
CLAMP
FUEL FILTER
CLAMP
Fig. 19
MAINTENANCE
MUFFLER
Inspect and replace corroded muf
fl
er and spark arrester (if
equipped) as it could create a
fi
re hazard and/or damage.
IN-LINE FUEL FILTER (See Fig. 19)
The fuel
fi
lter should be replaced once each season. If fuel
fi
lter becomes clogged, ob struct ing fuel
fl
ow to car bu re tor,
re place ment is re quired.
•
With engine cool, remove
fi
lter and plug fuel line sec tions.
• Place new fuel
fi
lter in position in fuel line with arrow
pointing towards carburetor.
• Be sure there are no fuel line leaks and clamps are
properly positioned.
•
Immediately wipe up any spilled gasoline.
ENGINE OIL FILTER
Replace the engine oil
fi
lter every season or every other oil
change if the tractor is used more than 100 hours in one year.
NOTE:
If needed, remove lower dash covers using steps
from "Lower dash cover removal" section of this manual.
CLEAN AIR SCREEN
The air screen is over the air intake blower located on top
of engine. The air screen must be kept free of dirt and
chaff to prevent engine dam age from overheating. Clean
with a wire brush or compressed air to re move dirt and
stubborn dried gum
fi
bers.
Fig. 20
• Keep
fi
nished surfaces and wheels free of all gasoline,
oil, etc.
•
Protect painted surfaces with automotive type wax.
Except for the washout port (if equipped), we do not
recommend using a garden hose or pressure washer to
clean the outside of your tractor unless the engine and
transmission are covered to keep water out. Water in
engine or transmission will shorten the useful life of your
tractor. Use compressed air or a leaf blower to remove
grass, leaves and trash from outside tractor and mower.
CLEANING
• Clean engine, battery, seat,
fi
nish, etc. of all foreign
matter.
• Clean debris from steering plate. Debris can restrict
clutch/brake pedal shaft movement, causing belt slip
and loss of drive. See Fig. 20.
CAUTION:
Avoid all pinch points and
movable parts.
CLUTCH/BRAKE PEDAL
STEERING
PLATE
STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
CLEAN
TOP SIDE
Summary of Contents for TS 142X
Page 56: ...10 11 19 CL Printed in U S A ...
