Husqvarna TS 248G, Operator'S Manual

11

OPERATION

TRANSMISSION ENGAGED

TRANSMISSION DISENGAGED

Fig. 12

TO TRANSPORT (See Fig. 12)

When push ing or tow ing your trac tor, ensure transmission 

is disengaged by placing freewheel control in free wheel ing 

po si tion.  Free wheel control is located at the rear drawbar 

of tractor.
• 

Raise attachment lift to highest position with at tach ment 

lift control. 

• 

Pull freewheel control out and into the slot and release 

so it is held in the disengaged position.

•  Do not push or tow tractor at more than two (2) mph 

(3,2 km/h).

• 

To reengage transmission, reverse above procedure.

NOTE

:  To protect hood from damage when transporting 

your tractor on a truck or a trailer, ensure hood is closed 

and secured to tractor.  Use an appropriate means of tying 

hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER AT TACH MENTS

Tow only the attachments that are recommended by and 

comply with speci

fi

 cations of the manufacturer of your trac-

tor. Use common sense when towing. Too heavy of a load, 

while on a slope, is dangerous. Tires can lose traction with 

the ground and cause you to lose control of your tractor.

REVERSE OPERATION SYSTEM (ROS) 

(See Fig. 11)

Your tractor is equipped with a Reverse Operation System 

(ROS). Any attempt by the operator to travel in the reverse 

direction with the attachment clutch engaged will shut off the 

engine unless ignition key is placed in the ROS "ON" position.

 WARNING:

  Backing up with the attachment clutch en-

gaged while mowing is strongly discouraged. Turning the 

ROS "ON", to allow reverse operation with the attachment 

clutch engaged, should only be done when the operator 

decides it is necessary to reposition the machine with the 

attachment engaged. 

Do not mow in reverse unless 

absolutely necessary

.

USING THE REVERSE OPERATION SYSTEM

Only use if you are certain no children or other bystanders 

will enter the mowing area.
• 

Depress brake pedal all the way down.

• 

With engine running, turn ignition key counterclockwise 

to ROS "ON" position.

• 

Look down and behind before and while backing.

• 

Slowly depress reverse drive pedal to start movement.

•  When use of the ROS is no longer needed, turn the 

ignition key clockwise to engine "ON" position.

ROS "ON" 

POSITION

ENGINE "ON" POSITION

(NORMAL OPERATING)

02828

Fig. 11

TO OPERATE ON HILLS 

CAUTION: Do not drive up or down hills 

with slopes greater than 15° and do not 

drive across any slope.

• 

Choose the slowest speed before starting up or down 

hills.

• 

Avoid stopping or changing speed on hills.

• 

If stopping is absolutely necessary, push brake pedal 

quickly to brake position and engage parking brake.

• 

To restart movement, slowly release parking brake and 

brake pedal.

• 

Slowly depress appropriate drive pedal to slowest set-

 ting.

• 

Make all turns slowly.

HOURMETER

The hourmeter shows the total number of hours the engine 

has run. To service engine and mower, see the Maintenance 

section of this manual.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped from the fac-

tory already 

fi

 lled with sum mer weight oil.

• 

Check engine oil with tractor on level ground.

• 

Unthread and remove oil 

fi

 ll cap/dipstick; wipe oil off.  

Reinsert the dipstick into the tube and rest oil 

fi

 ll cap 

on the tube.  Do not thread the cap onto the tube.  

Remove and read oil level.  If necessary, add oil until 

“FULL” mark on dipstick is reached.  Do not over

fi

 ll.

• 

For cold weather operation you should change oil for 

easier starting.  (See “OIL VISCOSITY CHART” in the 

Maintenance sec tion of this manual.)

• 

To change engine oil, see the Maintenance section in 

this manual.