11
Tuff Torq K61 Hydrostatic Transaxle
Motor Shaft Removal
9. Withdraw the Motor Shaft from the Motor Housing. If
the Shaft doesn’t back out freely, check to see if Snap
Ring was removed, see step 6.
(Fig. 29)
10. Remove the Snap Ring and Washer. Inspect the Washer
for wear or damage and replace if necessary.
(Fig. 29)
Fig. 29, Motor Shaft Removal
There is no need to remove the press-fit Bear-
ing on the Motor Shaft, unless it is damaged or worn.
Motor Housing Removal
6. Remove the Spring and Snap Ring. Next, remove the
Thrust Bearing Set seated in the Motor Housing.
(Fig. 27)
7. Inspect the press-fit Bushing in the Motor Housing for
burrs, scoring, pitting, discoloration, and wear. If dam-
aged, replace the Motor Housing. press-fit Bushings are
not serviced separately.
8. Remove the Snap Ring and Seal. Discard the Seal and
replace it with a new Seal during reassembly.
(Fig. 27)
Fig. 27, Motor Shaft and Housing
Fig. 28, Motor Shaft Assembly
Hydrostatic Pump Removal (continued)
