Knee Lifter
A
B
Your machine comes with a knee-lifter that allows you to lift
the presser foot with your knee. This is very helpful when
sewing, since it allows you to handle the fabric with your
hands while your knee lifts the presser foot.
Match the ribs on your knee-lifter with the notches in the
knee-lifter socket (A). Carefully push the knee-lifter into the
socket. Adjust the rectangular bar on the knee-lift until it is
positioned at a comfortable height for you (B).
Press your knee towards the knee-lifter and to the right, and
the presser foot will raise. You can raise the presser foot to
two positions; up and extra lift position.
To remove the knee-lift, just pull it straight out of the socket.
Front Cover
1
2
Set the machine in sewing position before closing the cover
Open by pushing the cover to the right (1) as far as it will go
and then pull it toward you (2).
Close it again by pulling the cover upward and then sliding it
to the left until it locks.
Note: The Threading/Sewing lever must be set in sewing position to be
able to close the front cover.
Note: The front cover has a safety switch and the machine will not sew if
the front cover is open.
Flat Bed Extension / Free Arm
To use free arm, remove the flat bed extension. The free arm
is convenient for sewing trousers legs and other small areas
such as children’s garments.
Pull the flat bed extension to the left to remove it.
To attach it again, place it around the free arm and push it
back to the right, until it clicks in place.
Note: The flat bed extension cover must also be removed to attach the
extension table.
11
