74
EMBROIDERY POP-UP MESSAGES
(PEURLGHU\XQLW
calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine area for
calibrating the embroidery arm. You will also be reminded to
VQDSRQWKH5IRRWIRUHPEURLGHU\3UHVVWKH2.EXWWRQWR
calibrate.
Note: It is very important to remove the hoop, otherwise the hoop or the
embroidery unit may be damaged while calibrating.
(PEURLGHU\XQLWQRWVXSSRUWHG3OHDVHUHSODFH
HPEURLGHU\XQLW
<RXFDQRQO\XVHWKHW\SHRI HPEURLGHU\XQLWWKDWLVGHOLYHUHG
ZLWK\RXUPDFKLQH$WWDFKWKHFRUUHFWHPEURLGHU\XQLW
$WWDFKFRUUHFWKRRS
When the size of the hoop on the machine does not match
WKHVL]HGLVSOD\HGRQWKH*UDSKLF'LVSOD\\RXUPDFKLQHZLOO
not sew. Change the hoop to the size displayed or change the
setting for hoop size to match your selected hoop, see page 72.
Check
XSSHUWKUHDG
Your machine stops automatically if the top thread runs out
or breaks. Re-thread the top thread and close the pop-up
PHVVDJHE\SUHVVLQJWKH2.EXWWRQ3UHVVWKH6WDUW6WRS
button to continue.
Cut thread end
When starting to embroider or after changing the thread, the
machine will sew a few stitches and then stop so you can cut
the thread end.
Note: This function is cancelled if ”Automatic Jump Stitch Trim” is
activated in the SET Menu, see page 32.
