Installation manual
H1 Self Contained Multideck
_________________________________________________________________________________________________________________________
Page
9
Hussmann
Daily
Case should be cleaned and inspected by store staff on a daily basis
Inspection
•
If an alarm system is not part of the refrigeration installation, the temperature of each case should be checked on
a daily basis via the thermometer that is installed
The case temperature should be within the following ranges
1
C
– 5
C
unless on defrost
If it is consistently outside the above temperature ranges, contact your service provider.
•
Visually check the case for damage or spills and take appropriate remedial action.
Clean
•
Do not use hot water on cold glass surfaces as the glass may shatter and cause serious injury.
•
When flushing the waste drain, do not use high-pressure water hoses and be careful not to introduce
water faster than the waste outlet/drain can drain it. The case does not have a floor drain. Do not bucket
more than 2 litres into the case during cleaning
CAUTION
Do not climb in or on the case as this may result
in personal injury and/or case damage.
1. Remove stock from the case and store below 5 °C
2. Turn off power to the case (electrical)
3. Remove all price tickets and any foreign materials from the case. Particularly the air return grill and defrost pan.
4. Remove shelves and clean with a sponge, warm water and mild detergent, then rinse and wipe dry
5. Remove the base trays, wash with mild soapy water and rinse.
6. Carefully flush the waste drain with a bucket of water and allow the base to drain.
7. Clean the drain area with a soft brush and warm water.
8. Clean the inside of the case (paying particular attention to the perforations in the rear panels) with a clean soft
cloth, warm water and mild detergent.
9. Clean glass or mirrored surfaces with a clean soft cloth and mild glass cleaner.
10. Wipe LED lamps with a dry cloth.
11. Clean bumpers and other plastic parts with a soft cloth and mild detergent, then wipe dry with a clean cloth
12. Clean the outside of the case with warm water and a disinfectant solution.
13. Replace base trays and shelves and turn on power.
14. Allow the case to attain correct working temperature (approximately 30 minutes) and restock the shelves.
NOTE: After cleaning, make sure to clean the area around the case to prevent slips and falls
