5-2
m
aIntenance
P/N 3093114_A
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
CLEANING AIRFLOW LOUVERS
Louvers should be cleaned at least every six
months. Dirty louvers adversely affect model
performance.
1. Remove screws and louver retainer.
2. Lift the louver, then rotate the bottom out.
3. Clean the louvers with soap and water. Dry
thoroughly.
4. When completely dry, re-install louvers and
retainer.
CLEANING WIRE RACKS,
PANS, AND INTERIOR PANELS
With the louver assembly removed, all interior
wire racks, supports and drip pans may be
lifted out without tools. Refer to illustration
on next page.
Begin by lifting out the display racks and
front and back display rack supports. Remove
display pans, beginning from the left. Pans
overlap when properly installed.
Carefully lift up glass package guard to clear
clips attached to front panel. It is not
necessary to remove clips from panel. Lift out
return air grilles. The glass may be cleaned
with most domestic detergents, ammo-
nia-based cleaners and sanitizing solutions
with no harm to the surface.
n
ever
use
abra
-
sive
cleansers
or
scouring
pads
.
Front and rear internal panels rest on interior
panel supports. Panels and supports lift out.
Reinstall in reverse order.
CLEANING STAINLESS STEEL RAILS
Use non-abrasive cleaning materials, and
always polish with grain of the steel. Use warm
water or add a mild detergent to the water and
apply with a cloth. Always wipe rails dry after
wetting.
Use alkaline chlorinated or non-chlorine
containing cleaners such as window cleaners
and mild detergents. Do not use cleaners
containing salts as this may cause pitting and
rusting of the stainless steel finish. Do not use
bleach.
Clean frequently to avoid build-up of hard,
stubborn stains. A stainless steel cleaning
solution may be used periodically to minimize
scratching and remove stains.
Rinse and wipe dry immediately after cleaning.
Never use hydrochloric acid (muriatic acid) on
stainless steel.
