Medium Temperature
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
JOINING INSTRUCTIONS
Sectional construction means that two or more
merchandisers may be joined in line yielding one
long continuous display requiring only one pair of
ends.
A
LL JOINTS MUST BE AIR
-
TIGHT TO PREVENT
FORMATION OF ICE OR CONDENSATION
.
Prep Case
1. Check to be sure that merchandisers are level
and that the factory-installed nut retainers and
alignment pins are in place. Locate Joint Kit
and check contents against parts list.
2. Remove shelves (if installed), display racks,
pans, front shelf supports and front air grilles
from the right end.
3. Remove the rear panel(s) from the right end.
On multi-deck cases remove the lower back
panel first. To remove a panel lift it up from
its bottom edge and out. No tools are
required.
Apply Gaskets
1. Insert donut gasket into the end frame
horizontal recess across the bottom and up the
front of one merchandiser as shown.
2. Apply the
1
/
2
in. (13 mm) gasket around the
perimeter of case and across the top as shown.
Be sure to overlap gaskets as shown. Check to
be sure that there are no gaps between gasket
and merchandiser.
Fasten Cases
1. Move the second merchandiser into position
against the first. Match the alignment pins
with the corresponding holes.
2. Fasten fronts together using cap screws, flat
washers, lock washers and nuts. Tighten only
until front panels touch. Do not tighten fully.
3. Use the cap screws, flat washers and lock
washers provided in the joint kit to draw mer-
chandisers together at rear. Do not tighten
fully.
4. Draw canopies of multi-deck wall
merchandisers together by inserting
threaded rod through top shoe as
shown. Fasten each end with washers
and nuts. Tighten only until canopies
touch.
5. Tighten joints in the order shown
(A, B, C, D) until gaskets are
compressed, and cases join smoothly.
1
/
2 x1
/
2
in. Gasket
Donut Gasket
CW2G and
CW2XG
A
A
D
C
B
B
C
D
Tighten in Order Shown
IMPORTANT
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets;
always overlap them as shown.
• Remove paper backing
after gasket has been applied.
