P/N 428668A
See the case data sheet set for dimensions. Each
waste outlet will be interconnected with factory
installed drip piping. When unitized cases are
joined, or an end case is to be joined to a lineup of
CW2 models, the waste outlet can be inter-
connected. A drain piping connect kit is required
to change piping from front to back as shown.
Each merchandiser is supplied with a 2 in. (51mm)
water seal, an adapter, a plug and a street ell. The
street ell and water seal must be installed to
prevent air leakage and insect entrance into the
merchandiser. They should be installed as shown
above.
