P/N 428668A
SEALING SPLASHGUARD TO FLOOR
I
F REQUIRED
by local sanitation codes, or if
desired by the customer, splashguards may be
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how much
the floor is out of level.
To install the trim to the splashguard:
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be nec-
essary. This is to ensure a good and secure
installation.
2. Apply a good contact cement to the cove trim
and allow proper drying time according to the
directions supplied with the cement.
3. Install the trim to the splashguard so that it is
lying flush with the floor. D
O NOT SEAL THE
TRIM TO THE FLOOR
.
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a sili-
cone type sealer. Sealant must be removed and
replaced when servicing.
Splashguard
Cove Trim
Cement
