P/N 428668A
The illustration below shows the typical load limit
area for the CW2 family of cases.
SHELF ALIGNMENT
Taped to one of the shelves of each merchandiser
is a small plastic bag containing shelf alignment
strips. These strips are designed to enhance the
appearance of the shelves by aligning the front
edge of each shelf with that of an adjacent shelf.
When installing shelves:
1. Insert one of the alignment strips into the slot
behind the front edge of each shelf.
2. After all shelves are installed, slide the strip
across the shelf joint wherever two shelves are
adjacent. This will lock them together.
MULTI-DECK SHELF CONFIGURATION
The bottom display shelves can be adjusted to
accommodate shallow or volume displays (bulky
items such as hams or chickens). The upper shelves
are individually mounted in 1 in. (25 mm) incre-
ments and have two-position brackets permitting
shelves to be placed in a flat or down-tilt position
(see illustration). Front product stops are recom-
mended when shelves are placed in the down-tilt
position.
Faceted shelves in end compartments are NOT
adjustable.
Shelf Alignment Strip
(
5
/
8
x 6 in. —16 x 152 mm)
NOTE: Older Lighted Shelves with
into the socket in the back panel.
