INSTALLING END ASSEMBLIES
End assemblies are normally factory
installed. The following information
is provided for retrofit or field instal-
lation.
1
Uncrate
Place glass crate on flat surface
with braces down as shown in
Figure 1, Detail A. Remove
screws from top.
Lift off top as shown in Detail B
of Figure 1.
Remove cardboard packaging
as shown in Detail C of Figure 1
and inspect Glass and Extrusion
for damage.
Carefully unpack crate with end
assemblies. Check for damage.
Locate and identify the parts
listed on Page 1.
Figure 1 — Uncrate and Inspect Glass
P/N 0503025_A
2
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
Detail A
Detail C
Detail B
