2
CABINET CAPACITIES –
Cabinet
Model
Cu.
Capacity (9 1/2 dia. 3 gal cans)
# of lids
DVG Ft. Upper Display Lower Display
-8 8.9 8 4
1
ELECTRICAL DATA
Cabinet
Compressor
Cabinet
Model Volts HP L.R. F.L. Nominal Fuse
DVG
Amps Amps Run Amps Amps
-8
115
1/2 51.0
7.9
8.4
15
INSTALLATION and START UP
LOCATION –
The location of your cabinet is important. Make sure your selected location is NOT in any
of the following areas as it could seriously affect the operation.
•
Not in direct sunlight.
•
Not in the air path of heat or air conditioning ducts.
•
Not at an exit or entrance affected by extreme temperature change.
Allow 2 feet of clearance at the rear of the case to allow adequate air movement across the
condenser for proper refrigeration system performance, do not obstruct the grille at the
rear intake and discharge.
Level case front to back and end to end, shimming where necessary upon installation to
assure proper operating drains, and refrigeration system.
POWER REQUIREMENTS –
The DVG model is equipped with a three-wire grounded service cord for your protection.
The cabinet is designed to operate on 115V single-phase 60hz current. A separate circuit is
recommended to prevent product loss due to overloading or malfunction of other
equipment on the same circuit. Use a time delay fuse or circuit breaker. The supply circuit
must be properly grounded and conform to National and Local Electrical Codes. Voltage,
as measured at the compressor terminals during operation, must not vary more than 5%
from cabinet serial plate rating. If a low voltage condition exists, contact your electrician
or Power Company.
