Hussmann ESBDVS, Joining Instructions

2

Apply 1 

5

/

8

in. (41 mm)

Gasket (Item – 2) 

to rear

foam panel of both cases as
shown. Check to be sure that
there are no gaps between
gasket and merchandiser.

N

N

O

OT

TE

E

:: 

T

HIS IS THE ONLY GASKET

THAT IS APPLIED TO BOTH CASES

.

T

HE FOLLOWING STEPS MUST BE

DONE TO ONE CASE ONLY

.

S

EE

F

IGURE

3, D

ETAIL

A.

3

Apply 

1

/

2

in. (13 mm)

Gasket

(Item – 3)

to the horizontal

recess across the bottom and
on the edge of the glass. 

See Figure 3, Detail A.

•Do not stretch gasket, espe-

cially around corners.

•Do not butt gaskets; always

overlap them as shown.

•Remove paper backing after

gasket has been applied.

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)

3

Figure 3. Applying 1

5

/

8

in. and 

1

/

2

in. Gaskets to the Merchandiser

Figure 2. Checking Alignment Pins

Vertical Glass Service Merchandisers Joining Instruction

P/N  0430502

2

3

Apply 1 

5

/

8

in.

(41 mm) 

gasket to both cases.

Gasket

Make sure the Alignment Pins (Item – 1) in the front near the
bumpers and at top front are in place before gasketing and
sealing cases. See Figures 2 and 3.

IMPORTANT

Installing Gaskets:

Alignment Pins

DETAIL A

.

2

1

1

Alignment Pin