Low Temperature
Excel
P/N 0467434_P
3-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
To install the cove trim to the splashguard:
1. Remove all dirt, wax and grease from the
area of the splashguard where adhesion will be
necessary to ensure a secure installation.
2. Apply a good contact cement to the cove
trim and allow proper drying time according
to the directions supplied with the cement.
3. Install the trim to the splashguard so that it
is lying flush with the floor.
d
o
not
seal
the
trim
to
the
floor
.
4.
If required by local health codes
the Cove
Trim may be sealed to the floor, using a
silicone type sealer. Sealant must be removed
and replaced when servicing.
