Low Temperature
Excel
P/N 0467434_P
5-1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
CARE AND CLEANING
Long life and satisfactory performance of any
equipment is dependent upon the care it receives.
To ensure long life, proper sanitation and
minimum maintenance costs, these merchandisers
should be thoroughly cleaned, all debris removed
and the interiors washed down, weekly.
Fan Plenum
To facilitate cleaning, the fan plenum is
hinged. After cleaning be sure the plenum
is properly lowered into position
or
produCt
loss
will
result
due to improper
refrigeration.
Exterior Surfaces
The exterior surfaces should be cleaned with a mild
detergent and warm water to protect and maintain
their attractive finish.
n
ever
use
abrasive
Cleansers
or
sCouring
pads
.
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners and
sanitizing solutions with no harm to the surface.
D
o
N
ot
U
se
:
• Abrasive cleansers and scouring pads, as these
will mar the finish.
• A hose on lighted shelves or submerge the
shelves in water.
• Solvent, oil or acidic based cleaners on any
interior surfaces.
• Ammonia-based cleaners on acrylic parts.
• Coarse paper towels on coated glass.
D
o
:
• Remove the product and all loose debris to
avoid clogging the waste outlet.
• Store product in a refrigerated area such as a
freezer. Remove only as much product as can
be taken to the freezer in a timely manner.
•
First turn off refrigeration, then disconnect
electrical power.
• Thoroughly clean all surfaces with soap and
hot water.
d
o
not
use
steam
or
high
water
pressure
hoses
to
wash
the
interior
.
t
hese
will
destroy
the
merChandisers
’
sealing
Causing
leaks
and
Poor
PerformanCe
.
• Lift hinged fan plenum for cleaning. Hook
chain in rear panel to secure plenum during
cleaning.
B
e
sure
to
rePosition
the
fan
Plenum
after
Cleaning
merChandiser
.
• Take care to minimize direct contact between
fan motors and cleaning or rinse water.
• Rinse with hot water, but do NOT flood.
n
ever
introduCe
water
faster
than
the
waste
outlet
Can
remove
it
.
• Allow merchandisers to dry before resuming
operation.
• After cleaning is completed, turn on power and
refrigerant to the merchandiser.
• Verify that merchandiser is working properly.
Prevent injury.
a
lwaYs
shut
PoweR
off
during cleaning process.
MAINTENANCE
Product will be degraded and may
spoil if allowed to sit in a non-
refrigerated area.
Do NOT use HOT water on COLD glass
surfaces. This can cause the glass to
shatter and could result in personal
injury. Allow glass fronts, ends, and
service doors to warm before applying
hot water.
