P/N 3003960_A
3-1
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
GSVM 4060F Merchandisers
START UP
GSVM 4060F self contained merchandiser has
its own evaporator coil and a TXV.
a. Check the interior cabinet thoroughly for
loose nuts, bolts and electrical connections.
b. Inspect the refrigeration lines for visible
damage or chafing.
c. Replace electrical box cover and access
panel.
d. Turn on the electrical power, power switch
and start the merchandiser. The merchan-
diser must pull down in temperature.
Allow merchandiser 24 hours to operate before
loading product.
CONTROLS AND ADJUSTMENTS
1. The Safe-Net III controller controls refriger-
ation temperature. This is factory installed in
the control panel. Adjust this control knob to
maintain the discharge air temperature shown.
Measure discharge air temperatures at the center
of the discharge honeycomb.
Defrosts are temperature controlled for self
contained. The defrost setting is factory set as
shown below.
LOAD LIMITS
Each merchandiser has a load limit decal. Shelf
life of perishables will be short if load limit is
violated.
A
t
no
time
should
merchAndisers
be
stocked
beyond
the
loAd
limits
indicAted
.
d
o
not
block
Air
louvers
.
STOCKING
Product should NOT be placed inside the
merchandisers until merchandisers are at
proper operating temperature.
Allow merchandiser 24 hours to operate before
loading product.
Proper rotation of product during stocking is
necessary to prevent product loss. Always
bring the oldest product to the front and set
the newest to the back.
START UP / OPERATION
GSVM 4060F
GSVM 4060F
-20° to -5°F
1
Electric
45°F
60
Summary of Contents for GSVM4060F
Page 2: ......
Page 4: ......
Page 44: ...Hussmann Corporation 12999 St Charles Rock Road Bridgeton MO 63044 2483 www hussmann com...
