P/N 3003960_A
4-3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
GSVM 4060F Merchandisers
CLEANING UNDER DISPLAY PAN
Remove all product from the merchandiser
and place in cooler. Always disconnect electri-
cal power before cleaning.
1. Remove the display pan
2. Use non-abrasive cleaning materials and a
mild detergent to clean display pan.
3. Wipe down the insides of the merchandiser
with a mild detergent, and replace display
pan. Allow merchandiser to pull down in
temperature before loading product.
CLEANING EVAPORATION PAN
The condensate water outlet for self
contained models empties into a limited
capacity evaporation pan.
Debris or dirt accumulation inside the conden-
sate evaporation pan or on the heater coil will
reduce the pan’s evaporation capacity and
cause premature heater failure. The evaporation
pan waste water will overflow and spill onto the
floor if the heater is not properly operating.
Remove accumulated debris from the evapora-
tion pan. Wipe down heater coil with a cloth
and warm water. Be sure to remove any dirt,
debris or liquids from the heater coil.
Water introduced during cleaning will cause
the evaporation pan to overflow.
CLEANING COILS
Condenser coils should be cleaned at least
once per month. Additional cleaning may be
needed depending on the operational environ-
ment. A dirty condenser blocks normal airflow
through the coils.
Evaporation Pan is Hot!
and poses risk of bodily injury
–
Always wear
gloves and protective eye wear when servicing.
Turn off evaporation pan heater, and allow
pan to cool.
Fan
Summary of Contents for GSVM4060F
Page 2: ......
Page 4: ......
Page 44: ...Hussmann Corporation 12999 St Charles Rock Road Bridgeton MO 63044 2483 www hussmann com...
