P/N 0515297_E
1-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
HGM Merchandisers
MERCHANDISER LEVELING
B
e
sure
to
position
merchandisers
properly
.
Level the merchandiser at corners.
Merchandiser(s) must be installed level to
ensure proper operation of the refrigeration
system and to ensure proper drainage of
defrost water. The merchandiser can be leveled
by shimming under the cabinet base frame, or
by installing optional leg levelers.
The self-closing doors require the cabinet to be
properly leveled. End to end leveling will allow
the door(s) to close with uniform speed and
tightness. A slight pitch from front to rear
is desirable.
t
he
Back
of
merchandiser
should
never
Be
higher
than
the
front
.
LEG INSTALLATION (Top Mounts Only)
Install the NSF approved legs after the case is
near its final location. The legs are packaged
inside the cabinet. Replace the tape and door
blocks.
To install legs:
Raise one end of the cabinet about 8 inches.
Block the merchandiser securely, and install
two legs. The leg mounting plates are factory
installed and contain a
1
/
2
x 13 in. tapped hole
to mate with the leg assembly. The procedure
is repeated on the opposite end. Three-door
merchandisers require legs in the center.
The cabinet should now be positioned at its
final location with all legs installed. The
merchandiser is leveled by turning the bottom
section of each leg . End to end leveling will
make the door(s) close with uniform speed and
tightness. A slight pitch from front to rear is
desirable.
SERIAL PLATE LOCATION
The serial plate is located in the upper left-
hand corner of the merchandiser’s interior.
The serial plate contains all pertinent
information such as model, serial number,
amperage rating, refrigerant type and charge.
Do not remove the serial plate under any
circumstance.
Serial Plate
Drain
(HGL-BS Shown)
Summary of Contents for HGM-1 BS
Page 2: ......
Page 4: ......
Page 70: ...Hussmann Corporation 12999 St Charles Rock Road Bridgeton MO 63044 2483 www hussmann com...
