HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
IM-H 1-5
Hot Merchandiser
ISLA IM-H
ISLA LIFTING AND TRANSPORT INSTRUCTIONS
6. 00 0"
12. 00 0"
6. 000"
12 .0 00 "
LI FT /RAISE
ZO NE
30.0 31 "
18.0 31 "
18 .031"
33 .675 "
1. The ISLA can be lifted by a forklift only at the specified location in the diagram
Improper placement of forks may damage
drainage piping. Use a spotter when placing forks.
Make sure that piping will not be damaged.
Use J-Bars or Jacks if Forks cannot be used safely
WARNING
Improper placement of forks may damage
items under the case. Use a spotter when placing forks.
Make sure that electrical, etc. items will not be damaged.
Use J-Bars or Jacks if Forks can not be used safely
2. Remove close-offs and lower body panels before lifting with a forklift. Serious damage will occur if the body
panels are not removed.
• Remove the end case lower and bottom panels first
• Then remove the side case lower and bottom panels
• A Phillips head screwdriver/drill is needed for lower and bottom panel removal
3. Make sure that fork spacing and width will not damage electrical lines
4. Be sure that the forks are long enough to support beyond the center of the case. Check for proper balance
before moving. A minimum fork length of 36” is recommended for 68” wide cases
5. The ISLA can be raised at one end with a forklift to allow the placement of rollers or dollies. See figure on page
next page for J-bar and jacking instructions
6. Never drag or push the ISLA by ANY COMPONENT including ANY GLASS COMPONENT. This will result in
damage to the base, and possibly damage to other components
7. Evenly support the entire base structure on rollers or dollies before attempting to move.
Installation (Cont’d)
