HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
IM-H 1-1
Hot Merchandiser
ISLA IM-H
NOTE: READ ENTIRE INSTALLATION
SECTION PRIOR TO BEGINNING
INSTALL
UNLOADING CASES FROM TRAILER
To protect the case and its base from damage
and make positioning the case easier, each
merchandiser can be shipped differently, depending
on the original order request. Your case(s) could be
on a skid, rails, crated and skidded, or just blanket
wrapped.
Improper handling may cause damage to the
merchandiser when unloading. To avoid damage:
1. Do not drag the merchandiser out of the trailer.
Use a Johnson bar (mule, aka J-bar), a dolly or
a forklift.
2. Use one or two dollies depending on length of
the case to remove the merchandiser from the
trailer.
3. Use one to two dollies to relocate the
merchandisers to the lineup.
NOTE:
When lifting case, be sure to lift case from
a point on
case body
. Improper lifting may
damage factory-installed end panels.
See Following Diagramed Pages
REMOVING SHIPPING SKID AND/OR
CRATE
DO NOT TILT or LAY MERCHANDISER
ON ITS SIDE.
1. Check floor where cases are to be set to see if
it is a level area. Determine the highest part of
the floor.
2. If the case is crated, unscrew/remove nails
from
one (1) of the walls
of the crate, leaving
three (3) sides and the top of the crate.
3. Then unscrew/remove the nails from around
the base of the crate (frame), releasing it from
the skid.
4. CAREFULLY remove/slide away the remaining
3 walls and top of the crate. (body panels
should be on the case, but if they are not,
carefully remove and set aside in safe place
so as not to be damaged/scratched)
5. Remove any braces/L-brackets attaching the
merchandiser to the skid.
6. Remove the merchandiser from skid, by lifting
only at base of case, using the case’s rails!
7. Once the case is removed from the skid, the
merchandiser must be lifted
—NOT PUSHED—
to reposition.
RECYCLE SHIPPING
BRACES AND
PACKAGING
HUSSMANN AND HATCO SERIAL PLATE
LOCATIONS
DOCUMENT ALL SERIAL NUMBERS
PRIOR TO HEATING!
Depending what type of case ordered (with or
without rear doors on the back of the case), the
Hussmann serial plate is either located:
1. (no rear on back) the top FRONT left-hand
interior rear wall
2. (with rear loading doors) in the lower left
corner on the BACK of the case.
Make note of the case’s serial number in the area
provided at the end of this guide.
HATCO serial numbers for each of the surface
warmers are located under each warmer.
Document the serial numbers in the space
provided at the end of this guide.
EXTERIOR INFORMATION
Do
NOT
walk on top of or inside of merchandisers
or damage to the merchandisers and serious
personal injury could occur.
They are not
structurally designed to support excessive
external loading such as the weight of a person.
Do not place flammable materials or objects on top of
the merchandiser.
2. Installation
