©2009 HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
U.S. & CANADA 1-800-922-1919 • MEXICO 1-800-522-1900 • WWW.HUSSMANN.COM
3
P/N 0512888_A
01 October 2009
MAXI-140
Hussmann Beer Merchandiser
MAXI-140
Optional Leg Kit
To maintain NSF standards of cleanability
when sealing cannot be done, Hussmann offers
optional leg kits that raise the MAXI-140
four or six inches. Directions are included with
the optional leg kit (Aftermarket
P/N TP.4900288).
LEVEL
Hussmann Beer Merchandisers must be level
front-to-back and side-to-side to operate at
peak efficiency. Shimming may be necessary.
Ensure all sides are firmly supported. Use care
when shimming legs.
PLUG IN
Put the Hussmann Beer Merchandiser on its
own dedicated electrical circuit with ground.
12AWG is the minimum size wire acceptable.
• The
MAXI-140
requires a dedicated 15 Amp
circuit with grounded wall
receptacle
(NEMA 5-15P)
• Do not use extension cords.
Never use adapters.
• If in doubt, call an electrician.
Electrical requirements for the merchandiser
are stated on the serial plate attached to the
unit.
If the power supply oscillates beyond the range
given in the preceding table, install a voltage
regulator.
Light Switch
The MAXI-140 merchandiser light switch is
located on the right rear of the interior top
panel. It controls the exterior canopy light;
LED lighting is
ON
at all times.
MAXI-140
MAXI-140
MAXI-140
MAXI-140
NEMA 5-15P
MAXI-140
MAXI-140
1000 VA
Nominal
Voltage
Minimum
Voltage
Maximum
Voltage
120
108
132
Light switch
IMPORTANT:
After leveling, wait at least 30 minutes
before turning on power to the Hussmann
Beer Merchandiser to allow any oil residue
to return to the compressor.
Oil not in the compressor at start up may
cause permanent damage not covered by
warranty.
Summary of Contents for MAXI-
Page 20: ......
