Hussmann MBC, Installation And Service Instructions Manual

4 

MODEL DESCRIPTION  –  
 
              This instruction manual covers the mer-
chandisers listed below. All models are available 
in 36” or  48” lengths. 

 
MBC – Self-Contained Self Service 
Beverage Case  
 
MBCR – Remote Self Service Beverage 
Case – Remote case requires a separate 
condenser unit connection. 
 

APPLICATION  - 
 
              The MBCR and MBC refrigerated mer-
chandisers are designed for use only in air condi-
tioned stores where temperature and humidity 
are maintained at or below 75ºF dry bulb tem-
perature and 55% relative humidity. 
 
              These Beverage Cases are intended for the 
storage and display of non -potentially hazardous, 
bottled or canned products only. 
 
INSPECTION UPON RECEIPT –  
 
              All equipment should be thoroughly exam-
ined for shipping damage before and during un-
loading.  This equipment has been carefully in-
spected at our factory and the carrier has as -
sumed responsibility for safe arrival.   
 
              If damage, either apparent or concealed, is 
found a claim must be submitted to the carrier. 
 
              Apparent Loss or Damage –  If there is ob-
vious loss or damage, it must be noted on the 
freight bill or express receipt and signed by the 
carrier’s agent; otherwise, the carrier may refuse 
the claim.  The carrier will supply necessary 
forms. 

             Concealed Loss or Damage –   When loss 
or damaged is not apparent until after equip-
ment is uncrated, a claim for concealed damage 
is made.  
              
             Upon discovering damage, make a re-
quest in writing to the carrier for inspection 
within 15 days and retain all packing.  The car-
rier will supply the inspection report and re-
quired claim forms. 
 
SHIPPING  –  
      
             Move the fixture as close as possible to 
its permanent location and then remove all 
crating. Check for damage before discarding 
packing.  Remove all separately packed accesso-
ries such as kits and shelves. 
 
LEVELING –  
 
             Merchandisers must be installed level to 
ensure proper operation of the refrigerant sys -
tem and to ensure proper drainage of defrost 
water.   
 
             Levelers are shipped with the case and 
should be installed in the same holes that the 
skid bolts were installed in. 
 
Place pry-bar under metal base and lift.  DO 
NOT LIFT END PANEL.  Turn leveler, with  
wrench clockwise to raise, and counter cloc k-
wise to lower.  Repeat process with other level-
ers until case is level. 
 
NOTE:  To avoid removing concrete flooring, 
begin lineup leveling from the highest point of 
the store.