1-2
I
nstallatIon
P/N 0515388_L
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
UNLOADING
Improper handling may cause damage to the
merchandiser when unloading. To avoid
damage:
1. Do not drag the merchandiser out of the
trailer. Use a Johnson bar (mule).
2. Use one dolly to remove the merchandiser
from the trailer.
3. Use two dollies to move merchandisers to
lineup.
4. Ensure that EcoVision II Doors are closed
and secured when moving merchandiser.
SERIAL PLATE LOCATION
Direct a flashlight through the return air grille
to locate the serial plate. The serial plate is
affixed to the inside of the left front assembly.
Since all electrical and refrigeration connec-
tions will be made at the front side, the fronts
will need to be positioned according to the
store plan layout.
EXTERIOR LOADING
Do NOT walk on top of merchandisers
or
damage to the merchandisers and serious
personal injury could occur.
T
hey
are
noT
sTrucTurally
designed
To
supporT
excessive
exTernal
loading
such as the
weight of a person. Do not place heavy objects
on the merchandiser.
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the merchandiser was shipped with the end
installed, two long bolts were used to hold the
shipping brace to the end. If the shipping bolts
are reinserted after removing the brace, they
will extend into the product area.
T
herefore
,
be
sure
To
replace
These
bolTs
wiTh
The
shorTer
bolTs
provided
.
NSF requires any
bolt or screw in the product area be capped
or cut off if it has more than three exposed
threads.
NOTE:
Be careful not to damage the factory
installed end while moving the case. Make
sure that tools are positioned past the end
and beneath the merchandiser’s support bar.
SHIPPING BRACES
Move the merchandiser as close as possible
to its permanent location and then remove all
packaging. Check for damage before discard-
ing packaging. Remove all separately packed
accessories such as kits and shelves. Remove
end braces and discard hardware.
SHIPPING RIDER
Each merchandiser is shipped on a rider to
protect the factory installed front legs, and to
make positioning the merchandiser easier.
DO
NOT remove the front rider until the merchandiser
has been positioned.
Once the rider is removed, the case must be lifted
Do NOT remove shipping braces until
the merchandisers are positioned
for installation.
Do NOT stand or walk on top of
merchandiser. Do not store items or
flammable materials atop the unit.
