Page 2
INTRODUCTION -
Hussmann USL models are self-
contained, low temperature, vertical solid
door reach-ins for the storage of ice cream
and frozen foods. Design features include
automatic defrost, efficient foamed in place
non-CFC insulation, and balanced refrigera-
tion systems for energy saving performance.
INSPECTION –
Upon receipt of the cabinet, carefully
examine the crating for damage. If the crate
is damaged, make a note on the delivery
ticket before signing. Carefully remove ship-
ping crate and examine cabinet for
“concealed damage. If damage is found, con-
tact the delivery carrier immediately and
have his agent prepare an inspection report
for the purpose of filing a claim. THIS IS
YOUR RESPONSIBILITY.
LOCATION –
The USL low temperature, storage,
self contained reach-ins are designed for
back room storage applications of ice cream
and frozen food products. Location where
drafts from air conditioning grille, fans and
open doors that would blow into the case
should be avoided.
CLEARANCE –
Because the condensing unit is located
at the top of the cabinet, at least 12 inches of
clearance should be allowed at the rear of the
cabinet and at the top of the case. This clear-
ance is necessary to provide free air move-
ment to and from the condenser for maxi-
mum operating efficiency.
INSTALLATION and START-UP –
SKID –
The skid should be left on the cabinet
until it is near the final location. The skid pro-
vides protection for both the case and floor.
The skid is removed by raising one end of the
case approximately six inches. BLOCK SE-
CURELY and remove the two skid bolts on the
raised end. This procedure is repeated on the
opposite end. When the skid bolts are re-
moved, the case may be slid off the skid.
LEG INSTALLATION –
After the case is near its final location
and the skid has been removed, the NSF ap-
proved legs should be installed. The legs are
packaged inside the cabinet. To install the
legs, replace the tape and door blocks. Raise
one end of the cabinet approximately 8 inches,
BLOCK SECURELY, and install two legs.
The leg mounting plates are factory installed
and contain a 1/2 x 13 tapped hole to match
with the leg assembly. The procedure is re-
peated on the opposite end. With the cabinet
legs installed, the cabinet should be positioned
in its final location and leveled.
The cabinet is leveled by turning the
bottom section of each leg. The self closing
doors require the cabinet to be properly lev-
eled. End to end leveling will make the doors
close with uniform speed and tightness. A
slight pitch from front to rear is desirable.
THE CABINET BACK SHOULD NEVER BE
HIGHER THAN THE FRONT.
TOP DECORATIVE PANEL REMOVAL –
The top decorative panel is removed by
sliding the panel up into the upper aluminum
Summary of Contents for USL-2
Page 15: ......
