VGM, VGD-0505
1 2
G L A S S R E P L A C E M E N T & R I G H T – L E F T A D J U S T M E N T
1. Open glass
2. Back out
panel.
all the set screws
Relieve the
along the top
tension on
edge of the glass
the hinge.
panel
(3mm set screw)
Back
of Case
Inside
of Case
PVC
U-channel
3. Use tip of
4. Slide glass panel
screwdriver to
in desired direction
gently tap loose
or remove panel
wedge the entire
length of the panel
Maintenance (cont.)
FOR PROMPT SERVICE
When Contacting the Factory
regarding problems, Be sure
to have the Case MODEL and
SERIAL NUMBER Handy.
This Information is on a plate
located on the case itself.
2.
Increase the height to 12", and raise and lower the
glass 6 more times.
3.
Finally, raise the glass to it's full extension. This should
release any settled lubricant in the cylinders, and
prevent any stress on the front glass. (1)(3)
