HUUV I Hate Yoga, Manual

Bluetooth connection

Activate the Bluetooth function of your phone or other device and pair it with the hoverboard  

(the connection will appear as “BLUETOOTH”) to use the on-board sound system.

Operation

Practice riding the hoverboard in an open space and on a level surface until you can mount the 

device, ride forwards and backwards, turn, stop and dismount.

Do not allow the wheels of the hoverboard to lose contact with the driving surface (THIS CAUSES 

A VERY GREAT RISK OF LOSING CONTROL).

Attend to safety and use protective gear to avoid injury.

Step 1

. Start the hoverboard by pressing the power switch.

Step 2

. Prepare for riding by stepping onto a pedal. The indicator light will appear and the sensors will engage with the 

system to balance the hoverboard. Put your other foot on the other side, find your balance and step onto the pedal to 

stabilise the hoverboard.

Step 3

. Adjust your balance when mounting the hoverboard and keep the device stable. Direct the hoverboard 

forwards and backwards by leaning in these directions. These movements should be gentle.

Step 4. 

Steer the hoverboard by accelerating forward movement with your left foot to turn right, and with your right 

foot to turn left.

Step 5

. Always ensure that the hoverboard has stopped and stabilised before dismounting. Step backwards off the 

device one foot at a time.

Charging the hoverboard

The charging light will blink to indicate that the hoverboard battery needs recharging. Stop riding the hoverboard and 

recharge it at the earliest opportunity. A low battery level can make the hoverboard more difficult to control, increasing 

the danger of falling off and causing other hazards.

Make sure that the socket is dry, and then plug the charger into a mains power outlet.

Check that the green indicator light comes on and then plug the charger into the charging socket of the hoverboard.

The charger indicator light will turn red during charging. Check the connections if this indicator light does not turn red.

The indicator light will turn green again when the hoverboard is fully charged. You should then disconnect the charger. 

Unnecessary and prolonged charging periods will shorten the life of the battery.

Charging takes about 2-3 hours depending on the conditions.

Make sure that the charging conditions are clean and dry, and that charging takes place at the right temperature.

Do not attempt to charge the device at temperatures of less than 0 °C or more than 40 °C. It is advisable to charge the 

hoverboard at normal room temperature. Do not cover during chargin.

ATTENTION! Do not leave the device unattended during charging.

Daily maintenance and cleaning

Make sure that the power is turned off and that the charger cable is disconnected before performing any maintenance 

or cleaning.

Clean the surface of the hoverboard by wiping it with a soft damp cloth.

Do not use solvents or abrasive cleaning materials.

Do not use pressure washers or direct water jets for cleaning the hoverboard, and never immerse the device.

EN