12
11.
Unlock the table, use the table lock levers
(K
–fig. 6).
12.
Use the table hand wheels to begin milling.
13.
Lower the quill, use the micro-feed hand
wheel (O
–fig. 5) and lock it by using the
quill lock handle (N
–fig. 5). Any further
depth adjustment requires the unlocking of
the quill before using the micro-feed hand
wheel(O
–fig. 5). To unlock rotate the lock
handle counter-clockwise and push in.
5.6.2. In Drilling Mode
9.
Use the depth handle to bring the tip of the
drill bit to the surface of the work piece and
lock the quill with quill lock handle (N
–fig.
5).
10.
Set the drilling depth stop to required
depth.
11.
Unlock the quill lock handle (N
–fig.5) by
turning counter-clockwise and pushing it in.
12.
Begin drilling by using the quill feed levers.
5.6.3. In Tapping Mode
In general, speeds for tapping require low transmission
(turtle) mode.
9.
Use the depth handle to bring the tip of the
tapping bit to the surface of the work piece
and lock the quill lock handle.
10.
Set the depth stop (M
–fig.5) for tapping the
required depth.
11.
Unlock the quill lock handle (N
–fig.5) by
turning counter-clockwise and pushing in.
12.
Begin tapping by using the quill feed
levers.
NOTE: While tapping, pause the spindle down feed at
the bottom of the operation to allow the breaking
and reversal of rotation of the spindle.
! Warning: After daily use, disconnect machine
from power source or press emergency stop
switch to shut off the power completely. Do not
keep the machine connected over 24 hours, it
may cause damage to the machine.
Fig. 5
M
N
O
P
Summary of Contents for HU 45 DM
