7-3
Gear Box
1.
The oil inlet for the gearbox is located under the cover on top of the
gearbox. (See Fig. 7-3
○
A
)
2.
The drain is located on the left bottom side of the gearbox near the 10
step feed selection dial as shown by arrow
○
B
Fig. 7-3.
3.
Recommended lubricant is Shell Tellus No. 220 and should be changed
every 6 months.
Fig. 7-3
7-4
Tailstock Adjustment
1.
Unclamp the tailstock – clamping lever.
2.
Loosen the 2 hexagon head screws. (one on each side of tailstock)
3.
Using a test bar between dead centers, make necessary adjustments sign
the slotted adjusting screws. (one on each side)
4.
After adjusting re-tighten the two hexagon head screws and re-check for
alignment.
Fig. 7-4
31
Summary of Contents for HU 480 X 2200 VAC TOPLINE
