HVFL Unvented Gas Logs
16
59D1016
ELECTRICAL WIRING - MILLIVOLT
CONNECT REMOTE RECEIVER
THESE INSTRUCTIONS SUPERCEDE THE SECTION
ENTITLED “HEARTH MOUNT” IN THE MILLI-VOLT
HAND-HELD REMOTE INSTRUCTIONS SUPPLIED
WITH THE REMOTE.
1. Cut cable to length (approximately 1") for placement
in the fireplace.
. Strip back 1/4" of the insulation from both ends of each
wire.
3. Connect two .5 female connectors to the wires at one
end of the cable.
4. Insert the opposite end into receiver (special fitting on
Ambient remotes).
5. Connect the connectors to the two .5" male connectors
located on the right side when facing the unit
. Figure
19.
Do not let the wire touch the grate or burners.
6. Stick velcro pads with self-adhesive backing to side
of remote receiver and to the right side of the unit.
Figure 19
7. Attach remote receiver with velcro pads. Control switch
must face forward.
NOTE:
Heat reduces battery life. You can protect the
receiver and extend battery life by mounting the receiver
in a wall or other location outside the fireplace.
FP2813
remote receiver
Remote
Wire Con-
nectors
Remote
Receiver
FP813
Figure 19 -
Install Remote Receiver
INSTALL T-STAT SENSOR
OPTION SOLD SEPARATELY
1. Remove metal bracket and label from box.
. Peel away the paper backing on the label. Line up holes
in label with holes on the bracket. Right side of label
should flush with right side of bracket.
Figure 20.
Press
label firmly and smoothly to bracket.
3. Using Phillips screwdriver, install t-stat sensor to bracket
with two screws provided.
Figure 21.
Make sure the
thermo bulb wire is at the bottom of t-stat sensor.
4. Plug in wiring harnesses to back of t-stat sensor.
Figure
21.
HIGH
LOW
26D3317
THERMOST
AT
SETTING
FP2805
apply label
Align
Holes
Align Edges of
Label to Right Side
of Bracket
FP805
Figure 20 -
Apply Label to Bracket
HIGH
LOW
26D3317
THERMOST
AT
SETTING
FP2806
T stat
Wiring
Harnesses
T-Stat Sensor
Bracket
Screws
Thermo Bulb
FP806
Figure 21 -
Install T-Stat Sensor and
Wiring Harnesses
