HVFL Unvented Gas Logs
6
59D1016
FP2814
18 24 HVFL controls
FOR YOUR SAFETY, READ BEFORE LIGHTING
A.
This appliance is equipped with a piezo ignition device which lights the pilot. If piezo is not working
properly, refer to “Match Lighting” instructions on
Page 30
.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not attempt to light any appliance.
•
Do not touch any electric switch; do not use any phone in your building.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instruc-
tions.
•
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not
push in or turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D.
Do not use this appliance if any part of it has been under water. Immediately call a qualified ser-
vice technician to inspect the appliance and to replace any part of the control system and any gas
control that has been under water.
W
ARNING
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal injury
or loss of life.
OPERATING INSTRUCTIONS
Location of Piezo Ignitor, Control
Knobs and Switch on Millivolt,
Thermostat, and Manual Units
Piezo Ignitor
Ignitor Pilot
Switch
Hi/Lo Knob
LG814
