HWg-PWR 3 / 12 / 25 MANUAL
HW group
September 2013
page 27
Input tab
This tab is used to configure the parameters of dry contact inputs.
Input Dry Contacts section
For each input, you can define:
Name
– Name of the input, shown at the homepage and in alarm messages.
State Name
– Name of the respective dry contact state at the homepage and in alarm
messages.
o
Log. 0 – Open
– Name of the logic low (contact open, idle) state.
o
Log. 1 – Close
– Name of the logic high (contact closed) state.
Alarm Alert
– Defines the alarm state.
o
Disabled
– Alarm function is disabled.
o
0 (Active if Log.0)
– Alarm when the contact is open.
o
1 (Active if Log.0)
– Alarm when the contact is closed.
– Determines if an e-mail is sent when the Alarm state is activated or
deactivated for the respective input.
SNMP Trap
– Determines if a SNMP Trap is sent when the Alarm state is activated or
deactivated for the respective input.
