Poseidon2
– Family manual
HW group
www.HW-group.com
40 / 104
SNMP Access - communities (passwords)
Two different password can be configured. Each can be set for R or R/W access and can be
eventually disabled.
Most SNMP applications work with the following settings (default settings). For security
reasons, we highly recommend to change the R/W access password.
R (get, get next)
“public”
R/W (set)
“private”
Note:
SNMP Access settings are available at the SNMP Setup tab
What to do if you forget your password
Restore the factory-default configuration of the device by one of the following methods:
Use the
UDP Config
utility (must run on the same network segment).
Right-
click the line corresponding to the device and select “Load defaults” from the
pop-up menu.
Use the
DIP Load defaults
feature.
Toggle the DIP1 switch several times during the first 5 seconds after powering up the
device.
Connect to the
Serial Setup
(RS-232) and execute the
Load Defaults
function from
the terminal menu.
Access to the menu is: 9600/8N1, DIP1=1, Reset the device.
