HWAM 04201, User Manual

6

UPDATED 09/20/2013

chimneys in the standard for Chimneys, Factory-Built, Residential Type and Building Heating Appliance, 
UL 103, or 2) a code-approved masonry chimney with a fl ue liner.

For any unresolved questions about installation in the USA, refer to the national Fire Protection 
Association’s publication ANSI/NFPA 211 Standard for Chimneys, Fireplaces, Vents and Solid Fuel 
Burning Appliances. For installation in Canada, refer to CSA CAN-B365, Installation Code for Solid Fuel 
Burning Applications and Equipment. These standards are the basis for many national codes.  They are 
nationally recognized and are accepted by most local authorities. Your local dealer or your local building 
offi cial may have a copy of these regulations.

WARNING

!

CHECK ALL LOCAL BUILDING AND SAFETY CODES BEFORE INSTALLATION.  THE 
INSTALLATION INSTRUCTIONS AND APPROPRIATE CODE REQUIREMENTS MUST BE 
FOLLOWED EXACTLY AND WITHOUT COMPROMISE.  ALTERATIONS TO THE STOVE ARE 
NOT ALLOWED. DO NOT CONNECT THE STOVE TO A CHIMNEY SYSTEM SERVING ANOTHER 
STOVE, APPLIANCE OR ANY AIR DISTRIBUTION DUCT. FAILURE TO FOLLOW THESE 
INSTRUCTIONS WILL VOID THE MANUFACTURERS WARRANTY.

NOTE

If you plan to vent your stove into an existing masonry chimney, have the chimney inspected by a 
local fi re marshal or qualifi ed installer.  Remember that the chimney and its location on the roof heavily 
infl uences the stoves performance. An oversized fl ue may not provide effective draft and a fl ue  liner 
may be required. (Observe draft requirements).  Consult your dealer or qualifi ed installer before fi nal 
selection is made.

We advise you to leave enough room to enable cleaning between the stove and the wall.

Clearance to combustibles

One of the main necessary precautions you must take, when installing a stove is to leave suffi cient 
space between the stove (top, sides, back, front, and under stove pipes) and any  material that can 
catch fi re.