22
WIKING Scandic
WIKING Nordic 7
WIKING Nordic 9
WIKING Nordic 9G
WIKING Nordic 10G
Wood-burning stove’s weight
95 kg
93 kg
95 kg
The wood-burning stove’s di-
mensions
(height x width x depth)
894 x 527 x 426 mm 894 x 527 x 431 mm 1014 x 527 x 431 mm
Distance to furniture - front
800 mm
800 mm
800 mm
The stove is mainly made of sheet iron.
Connection to the chimney
The stove has a smoke outlet at the top and at the back. It can be installed with an approved smoke pipe
and a steel chimney, or connected to a brick chimney with a fullform smoke pipe.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
Changing the smoke outlet from top outlet to rear outlet
(WIKING Nordic 9G/WIKING Nordic 10G)
1.
Lift the stove top plate off.
2.
There is a cut-out in the rear plate for the smoke outlet. Break off the plate within this cut-out to make
a hole in the rear plate so there is room for the smoke outlet.
3.
Remove the cover plate on the back of the stove by removing the three screws (Torx Bit no. 30). Be
careful not to lose the screws behind the welded rear plate.
4.
Remove the three screws. Lift the flue ring off the top of the stove.
5.
Mount the cover plate on the top of the combustion chamber using the three screws (Torx bit no. 30).
6.
Insert the flue ring into the smoke outlet hole in the rear of the stove and secure it with the three
screws.
7.
Replace the stove top plate.
Installing soapstone in the heat compartment (WIKING Nordic 10G)
1.
Lift the stove top plate off.
2.
Place soapstone slabs in the heat storage compartment making sure that the hole in every slab is
right above the smoke ring.
3.
Replace the stove top plate.
Requirements for chimney and smoke pipe
The stove requires a draft of at least 12 Pa.
The chimney must be of a proper height to ensure that the draft is sufficient and that smoke does not
become bothersome. If the chimney is so high that it cannot be cleaned from the top, an easily acces-
sible cleaning hatch must be installed. We recommend that you always contact your local chimney sweep
before purchasing a chimney.
Minimum clearance: Ø150 mm, which corresponds to your WIKING wood-burning stove’s exhaust pipe.