Title
Revision.
Page
054 SERIES RELEASE2
R2.Ver2.0
P.13
2-5) Update (on Board)
By using flash memory ,it‟s able to simply update on the PC.
Please conduct the updates, after refering the following steps.
1) Please power off and on.
2) Please check if the PC is connected with printer.
* If use the USB Interface, the time will be saved to update.
3) Please conduct the given update program.
The update will be started after ERROR LED is off for 4 seconds.
* Please do not power off / switch off Dip switch until the update ends.
4) The update will be end, once the update complete appears on the screen.
※
If the ERROR LED is appeared as on and off continuously, it could be error.
Please repeat these steps again, and check the interface cable, and the connections.
5) You can use the updated printer after update, it will be reset automatically then power off & on.