Title
Rev.
Page
HPP-240
Ver1.0
P.10
2-4)
On-board Update
Printer program is easily updateable from PC with the Flash Memory equipped.
When updating, you should be well informed of the following order before executing.
1)Turn the power off and back on. (Dip SW manipulation is unnecessary)
2)Check the connectivity of Printer and the communication cable.
(You can save time updating by using USB cable)
3)
Run the update after configuring the model name and communication port through the
provided update program.
The ERROR LED will turn off and it will turn back on few seconds later, and the update
will start when the LED starts flashing rapidly.
Do not turn off the printer until the update is complete
4)
Update Complete notification will display when the process is complete.
※If the ERROR LED flashes slowly during the update, then the process is in error, so
you need to terminate the update program, and repeat the process from the direction
number 1) after checking the abnormalities on the device.
5) The printer will reset automatically after the update and will return to the ready to use
status.
