Title
Rev.
Page
HPP-240
Ver1.0
P.12
2-5-1) Manual Configuration
1) Run the printer in initial configuration mode.
※How to run in Initial Configuration Mode
When you turn the printer
’
s power on while pressing down on the FEED button for
more than 2 seconds, the PE LED and ERROR LED will simultaneously turn on / flash
and run the initial configuration mode. (9600 BPS, PARITY NONE, HARDWARE
HANDSHAKE)
2)After running the initial configuration mode, it will print as the following
.
[Menu]
1.Baud rate
2.Parity
3.Flow control
4.Hex Dump Mode
5.Print Density
6.Auto Melody
7.Cut Mode
8.Auto Buzzer
9.Print Speed
Select and then Enter...
Enter : Press the feed button once for
more than 1second.
Select: Press the feed button many times
less than 1second as menu number.
Exit : Turn power off then on.
Press the FEED button more than 1 seconds to confirm (Enter) less than 1 seconds to
select menu. For example, if you
’
d like to change the Auto Melody option in the list
number 6, press the FEED button less than 1 seconds 6 times, and more than 1 seconds
1 time. When terminating the configuration, just turn off and back on.
3)Continuing from the previous, you can confirm after selecting the category on the
printed list
.
Ex) [Baud rate]
-> 1.9600
2.19200
3.38400
4.115200
-> : Indicate current set status
Select and then Enter...
Meaning,
(->) indicates the current setting. When changing the settings, select from the
list and if you want to move to the next menu without making any changes, then just
confirm without selecting from the list.
