OPERATING PROCEDURES
MP35.5004
22JAN02
ROOM RETRACT PROCEDURE
CAUTION:
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF THE ROOM WHEN OPERATING.
1. Turn the ignition switch to ACCESSORY.
2. Press the "HYD" BUTTON.
To retract the room the HYDRAULIC OPERATION
LIGHT must be illuminated. A WARNING LIGHT does NOT
need to be on.
4. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted.
Releasing the ROOM CONTROL SWITCH will halt
the operation of the room.
6. Press the "OFF" Button or let the system continue to
STORE.
7. Turn the ignition switch off.
8. Engage all room-locking devices.
9. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
Room-locking devices should be locked
while traveling.
IMPORTANT:
The room can be retracted ten seconds after the
leveling system is put in the STORE mode. This will interrupt
the STORE mode unitl the ROOM CONTROL SWITCH
is released. The leveling system will continue to STORE
starting from the beginning of the program.
NOTE:
NOTE:
NOTE:
3. Insert the KEY and turn the KEY SWITCH to the "ON"
position.
5. Turn the KEY SWITCH to the "OFF" position and remove
the KEY.
IMPORTANT: If the leveling system is in the "STORE"
mode, do not press the "OFF" button.
HWH Customer Service for assistance 1-800-321-3494.
room. DO NOT reverse direction of the room, contact
room control switch immediately. DO NOT force the
If either side of the room stops moving, release the
after the room is fully retracted or stops moving.
in the "RETRACT" position for more than ten seconds
Do not hold the ROOM CONTROL SWITCH
reversed, DO NOT retract the room until the room
the room. If the direction of the room has been
of the room may be reversed, but watch for binding of
the room is fully retracted. If necessary, the direction
of the room, do not reverse direction of the room until
During normal operation
Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
has been fully extended.
pressurization of the cylinders.
IMPORTANT:
NOTE:
