HWH 610 SERIES, Operator'S Manual

OPERATING PROCEDURES

MP35.5018

06JUL05

JACK RETRACTION

the system in the store mode, the vehicle may be moved 

store mode.  If the engine was started before putting 

the jacks are in the STORE/TRAVEL position and the room

lights are out and the green "TRAVEL" light is on, providing

out.  The vehicle can be moved as soon as the red WARNING

Press the "I" button one time.  The "I" indicator light will glow

1. Turn the ignition switch to "ON", "ACC", or start the engine.

flash.  As each jack retracts, its red WARNING light will go

2. Press the "STORE" button.  The store indicator light will

The system must be allowed to completely finish the 

DO NOT push the "OFF" button or turn the ignition key.  

system while the "STORE" indicator light is blinking.  

AND THAT ALL PEOPLE ARE CLEAR OF THE VEHICLE.

THAT THERE ARE NO OBJECTS UNDER THE VEHICLE 

is fully retracted.

IMPORTANT: DO NOT interrupt power to the leveling 

steady.

CAUTION:

THE OPERATOR MUST BE SURE 

DO NOT MOVE THE VEHICLE WHILE THE

"WARNING" lights condition.

see MANUAL JACK RETRACTION Section.

CAUTION:

when the jacks are in the STORE/TRAVEL position.  This 

store for thirty (30) minutes, then shut down regardless of the

"WARNING" light does not go out, the system will continue to

four individual red "WARNING" lights are out.  If any one red

3. The system will automatically shut down six minutes after the

LEVELING JACKS OR THE ROOM EXTENSION ARE STILL

4. If jacks cannot be retracted by the above procedure 

IN CONTACT WITH THE GROUND OR IN THE EXTEND
POSITION. THIS VEHICLE IS EQUIPPED WITH STRAIGHT-
ACTING JACKS AND A ROOM EXTENSION. MOVING
THE VEHICLE WITH THE LEVELING JACKS AND/OR THE
ROOM EXTENDED CAN CAUSE SEVERE DAMAGE TO THE
JACKS OR THE VEHICLE AND CREATE A DRIVING
HAZARD. DO NOT RELY SOLELY ON THE WARNING
LIGHTS. IT IS THE OPERATOR’S RESPONSIBILITY TO 
VISUALLY CHECK THAT ALL JACKS AND THE ROOM EX-
TENSION ARE FULLY RETRACTED INTO THE STORE/
TRAVEL POSITION.

NOTE:
RETRACT will interrupt the STORE mode. The system 
will continue to STORE after the ROOM CONTROL 

Pushing the ROOM CONTROL SWITCH to 

EXTEND POSITION

STORE/TRAVEL POSITION

to the ground then retract the jacks again.

extended for an extended period of time and the jacks

NOTE: If the vehicle is parked or stored with the jacks

fail to retract completely, extend the jacks back down

will not interrupt the store procedure.

SWITCH is released.