OPERATING PROCEDURES
MP34.3337
27JUL15
MANUAL HYDRAULIC LEVELING
HYDRAULIC LEVELING SYSTEM.
CLEAR OF THE VEHICLE WHILE OPERATING THE
WARNING:
KEEP PEOPLE AND OBJECTS
UNDERSTAND OPERATOR’S MANUAL BEFORE USING
WARNING!
LIGHT
LOWER
RAISE
ON
RAISE
HOME
RAISE
LOWER
DUMP
LEVEL
HYD
RAISE
LOWER
LOWER
OFF
RESET
STOP
LEVEL
LIGHT (4)
SENSING
IMPORTANT: Do not continue to push an EXTEND
1. Place transmission in the recommended position for parking
2. Place pads under the jack feet if the ground will not support
the vehicle on the jacks.
6. The vehicle may be leveled using the manual RAISE
or LOWER buttons to operate the corresponding jacks. If
corner of the vehicle is low. It is best to level the vehicle
Jacks will extend (or retract) in pairs to raise (or lower) a side
or end of the vehicle.
button for more than ten (10) seconds after that pair of
7. When leveling is completed, turn the ignition switch to
the "OFF" position. The LCD panel will power down in
the vehicle, and set the parking brake. Turn the ignition to the
"ACCESSORY" position.
jacks are fully extended.
side to side first, if needed, before front to rear.
Any jack not used for leveling can be extended to the
ground. This provides additional stability against wind and
activity in the vehicle. Jacks used to stabilize the vehicle
after leveling is complete should lift the vehicle slightly after
touching the ground.
from the vehicle suspension.
5. Push the "DUMP" button. Wait until all air is exhausted
DOWN
LIGHT (4)
JACK
When a jack extends approximately 1 inch, it’s individual
red jack down light on the LCD panel will come on. If the
ignition is in the ON position, the warning buzzer will sound.
4. After pressing the "MAN HYD" button, the MANUAL HYD
3. Press the "MAN HYD" button on the HOME page. If the
park brake is not set, a message will appear on the screen.
Push the "HOME" button and correct the problem before
pushing the "MAN HYD" button again.
LEVEL page will appear.
five minutes.
a yellow LEVEL SENSING LIGHT is on, that side, end or
