5
INSTALLATION
1. Align holes in the
support
stand
①
and pad
②
,
then insert bolts and fasten with drum key(attached).
2. Insert tongue
③
of the kick stand into slot of the
pedal .
3.Adjust to a suitable position, and then fasten the
wing nut on the kick pedal.
Kick Installation
1. Align holes in the sound module and the model mount then insert
screws and fasten it.
2. Insert rod of the model mount into the clamp, then tighten the wing nut.
Sound module Installation
Connect the trigger connector cable plug to the bottom of the sound
module, and then connect all cable heads according to their name tags.
Electronic Connection
Finalizing the Installation
After install all components, fine adjust the arm, clamps and rods to the
best position you desire.
1. Remove the wing nut, washer and felt pad from the top of the rod.
3. Adjust the pad position then re-tighten the wing nut.
Cymbal Installation
COMPONENTS INSTALLATION
2. Put the cymbal pad into the rod, then place back parts removed in the
step 1. Fasten the wing nut but not too tightly. It allows the pad a little bit
wobbling like real acoustic cymbal.
2
1
3
1. Adjust the support hex rod to suitable position.
2. Loosen the bottom wing nut of the pad and insert it to the support hex rod. Push
the wing nut up a little bit and shake the pad to insert it successfully.
3. Fasten the bottom wing nut after the pad is adjusted to the suitable position
Snare & Tom pad Installation
2
3
1