Operation & Safety Manual
HB-P4.5 / HB-P5.0
SUPO 647
REV D
22
6.2 | Pre-start Inspection Checklist
This checklist must be used at the beginning of each shift or after every six to eight hours of use. Fail-
ure to do so could affect the safety of the operator.
MODEL NUMBER: SERIAL NUMBER:
Keep inspection records up-to-date.
Record and report all discrepancies to your supervisor.
A dirty machine cannot be properly inspected.
Y — Yes/Acceptable N — No/Unacceptable R — Repaired
Description
Y N R
Visual Inspections
Check that there are no damaged, dented, or bent structural members.
□ □ □
There are no loose or missing parts.
□ □ □
Check that warning and instructional labels are legible and secure. Ensure that load capacity is clearly
marked.
□ □ □
Check the platform rails and safety gate for damage.
□ □ □
Platform and base controls are not missing, damaged, or disconnected.
□ □ □
Electrical cables and wires are not torn, frayed, or disconnected.
□ □ □
Hydraulic hoses are not torn or loose, and there are no leaks. Check that hoses and cables have no
worn areas or chafing.
□ □ □
Check the tires for damage.
□ □ □
Check that all snap rings are secure in grooves on pivot pins.
□ □ □
Functional Tests
Gate closes automatically and latches (alignment can be adjusted with screw-on toe board or rail-
ing).
□ □ □
Platform Controls — Check all switches and push buttons for proper operation:
Emergency Stop (stops all movement)
Up/Down Controls (Elevates, Lowers, Enable button must be pressed)
□
□
□
□
□
□
Base Controls — Check all switches and push buttons for proper operation:
Emergency Stop (stops all movement)
Key Switch (Selects Platform Control, Ground Control, or Off)
Alarm (Not damaged, sounds for descent)
Up/Down Rocker Switch (Elevates, Lowers)
□
□
□
□
□
□
□
□
□
□
□
□
Wheels: Front and rear wheels rotate freely.
□ □ □
Brakes engage and hold when platform is elevated.
□ □ □
DATE
INSPECTED BY
WARNING
SECTION 6 | MAINTENANCE
