background image

 

  

C/

cw a 

MEDIUM PHONE

CAUTION

Both bands must be adjusted to
the same mode for proper
operation of the 

antenna,

AO-0330-A-005

110-DAY LIMITED WARRANTY

Hy-Gain Electronics Corporation Hy-Gain warrants for a period of 90 days from the date 

o

purchase by the original consumer purchaser as products manufactured by it and bearing
my-Gam model numbers to be free from detective material and workmanship under
normal use and service and agrees td repair of replace at our option such products, if
investigation discloses the defect to be the fault of our manufacture Hy-Gain's obligation
under this warranty is limited to repairing Of replacing any such product which upon out
examination proves td be so defective

This warranty applies only to the original consumer purchaser Upon receipt 

of 

equipment

the buyer is responsible for checking the contents for damage Any shipping damage
should be referred to the Garner

This warranty does not apply 

to 

any Hy-Gam products which have been repaired. worked

on. or alieted by persons not authorized by Hy-Gain to do so. or products the stability or
reliability or which nave been injured by such repair or which have been the Subject of

misuse negligence or accident Neither does this warranty apply 

to 

any 

our products

which has peen connected installed used, 

or 

otherwise adjusted other than In accordance

With instructions furnished by Hy-Gain

HY-GAIN ELECTRONICS DOES NOT ASSUME ANY LIABILITY FOR INCIDENTAL,
SPECIAL AND/OR CONSEOUENTIAL DAMAGES OF ANY KIND WHATSOEVER. AND
IN ANY EVENT. OUR LIABILITY SHALL IN NO CASE EXCEED THE ORIGINAL
PURCHASE PRICE OF THE PRODUCT

'

Some stares do not allow the exclusion or limitation 

incidental of consequential

damages. so

 the above limitation or exclusion may not apply td you

Accessories Supplied by. but not manufactored by Hy-Gain Electronics Corporation. shaft
carry only such warranty as is available from the manufacturer of such goods and are
spectficany excluded from this warranty

This warranty is void d Hy-Gain 

shall 

inspect ow equipment and find it 

to 

have been

modified or improperly installed or used The warranties contained herein are the sole
express warranties made by Hy-Gam Electronics Corporation on this product -_

LIMITATION OF DURATION OF IMPLIED WARRANTIES - IMPLIED WARRANTIES-
INCLUDING WITHOUT LIMITATION, WARRANTIES OF MERCHANTABILITY OR
FITNESS ARE EXPRESSLY LIMITED IN DURATION TO THE 90-DAY PERIOD 

OF 

THIS

WARRANTY

Some states do not allow limitation on now tong an implied warranty 

fasts. so

 the above

limitation may not apply to you

'

No Person. Including any dealer. agent. distributor or representative of Hy-Gain is
authorized to assume for Hy-Gam any liability 

do 

its behalf or in its name, except to refer

purchasers to tins warranty

All claims of defect or shortage should be sent postage prepaid to

Hy-Gain Warranty Service H

y

-Gain Electronics Corporation 4900 Superior

Avenue

' Lincoln. Nebraska 68504

To speed up

 

your claim you should mall the warranty card In immediately, though 

it is 

not a

condition of this warranty. That places your name on life and speeds up handling c any
claim you may have in the future However. f tot some reason you do not man in the card.
a copy of a document Such as a sates receipt recording the date, place- and proof of
purchase will, f Satisfactory to the service department, also serve 

to 

establish your

warranty rights Your warranty claim should include aft pertinent details- along with the pan
or hem numbers involved

Alt products subject td repair or replacement under Such warranty molt be mailed or
returned to the above my-Gain Electronics Warranty Service Station. transportation
prepaid by the purchaser within ninety days from the date of purchase by the original
consumer purchaser. We suggest that you notify the Warranty Service Station and obtain
prior authorization before you return the product Unexpected returns are greatly delayed in
handling These delays can be avoided by writing in advance and furnishing the necessary
information

Hy-Gam reserves the right 

to 

ship new and/or improved products which are similar to the

form, 

Ia. 

and function *(Products originally ordered Of purchased.

This warranty gives you specific legal rights, and you may also have other rights which
vary from state 

to 

State

HY-GAIN ELECTRONICS CORPORATION
8601 Northeast Hwy 6

'

Lincoln Nebraska 68505

Summary of Contents for DB-1015A












Reviews: