NOTE: ASSEMBLY HARDWARE FOR THE
DRIVEN ELEMENT BRACKET IS THE
SAME AS USED ON THE REFLECTOR
BRACKET.
DRIVEN ELEMENT DETAIL
DIRECTOR/REFLECTOR DETAIL
Figure 2 Element-to-
Boom Brackets
Assembly of the Driven Element
Select the parts as listed in Figure 3 and as-
semble them as shown in Figure 3. Before
tightening the hardware, make sure that:
NOTE: If you are adding the Discoverer 7-3
Director Kit to a preassembled Discoverer 7-
2, then you only need to readjust the DE5
section, "A"dimension, to that shown in Table
1 and position the driven element on the
boom.
DE1(Item No. 10) is inserted completely
into the driven element insulator.
DE 1 (Item No. 10) is positioned with the
small holes up and down.
Tighten the anchor bolts on the element-to-
boom bracket (Item No. 28) last. This will en-
sure that the element will not slip on the
boom.
DE1(Item No. 10) is positioned at 90
degrees from the boom-to-mast bracket to
that the element will be horizontal when
installed on the mast.
Summary of Contents for DIR-73
