2. When EDID is switched to STD the unit will use its built-in EDID which
supports:
Video → 1080p 8-bit or 12-bit (max)
Audio → PCM 2CH
3. The EDID selection will only activate when the unit is plugged in and
powered on.
④
System Reset: When switched “ON”, the system will send the internal CEC
to the display within 8~10 minutes to force all the displays to switch to
HDMI 1 input port. Meanwhile, the source’s CEC will not be functioning.
When switched “OFF”, the system reset function will be stopped. Factory
default is “OFF”.
⑤
Video/DDC input: These slots are for connecting the Video/DDC input to
the Video/DDC output of the transmitter unit with CAT6 cables.
⑥
Video/DDC output: These slots are for connecting the Video/DDC output
to the Video/DDC input of the receiver unit with CAT6 cables.
Note:
A. This system was tested with CAT6/23AWG/ cables, so if using cables
of another type, the user must be warned that this may result in a lower
maximum distance.
B. Cable distance tested with a PS3 40G, and 37" Samsung 12 bit LCD TV.
C. Figures provided in this manual are reference figures only, actual
figures may depend on source and display use with cable specification.
⑦
HDMI Outputs 2~8: These slots allow you connect to HDMI displays with
HDMI cables. When more than one output is connected, the HDMI
outputs will play an identical video signal.
⑧
Power: This slot is where you plug in the 5VDC power supply included in
the package into the unit and connect the adaptor to an AC outlet.
5
